Always ready to assist you

Call 855.894.3136

MultiCam Technical Support is your connection for help and advice on how best to utilize your MultiCam System.

 

FridayCutFacts: How to Get a Mirror Like Edge Quality When Cutting Acrylic

When cutting acrylic for applications where the edge will be visible and will need to be either polished or at least very smooth, it’s absolutely imperative that you get the cut right the first time. So, today we put our new 6mm Crown Norge Diamond bit to the test and were blown away by the results.

For our initial cut pass we used a 1/4 inch Super Upcut Bit on 1/4 clear acrylic at a feed rate of 150 in./min. and a speed of 28000 RPM’s.

 

Back to Blog

Leave a Reply

Stay Informed

Stay Informed

Get A Quote

Get A Quote